Flange butterfly valve

IntroductionFlange butterfly valves are widely used in industrial pipelines for regulating and isolating fluid flow due to their compact design, cost-effectiveness, and reliable performance. Proper installation and maintenance are crucial to ensure longevity, prevent leaks, and maintain operational efficiency. In this guide, we’ll walk you through the essential steps for installing and maintaining a flange butterfly valve. Installation of Flange Butterfly Valve 1. Pre-Installation Checks Inspect the valve, flange, and gaskets for any visible damage or defects. Ensure the valve is compatible with the pipeline media (e.g., water, chemicals, gas) and pressure rating. Verify that the flange dimensions match the pipeline flanges (e.g., ANSI, DIN standards). 2. Installation StepsStep 1: Prepare the Pipeline Clean the pipeline flange faces thoroughly to remove dirt, rust, or old gasket residue. Align the pipeline flanges properly to avoid stress on the valve. Step 2: Position the Valve Place the valve between the flanges, ensuring the disc is partially open to avoid damage during mounting. Insert the gasket between the valve and each flange for a secure seal. Step 3: Bolt Tightening Insert and hand-tighten all bolts evenly. Use a cross-tightening pattern (gradually increasing torque) to ensure uniform pressure and prevent distortion. Refer to the manufacturer’s torque specifications to avoid over-tightening. Step 4: Post-Installation Test Slowly open and close the valve to check for smooth operation. Conduct a pressure test (if applicable) to ensure no leakage at the flange connections. Maintenance of Flange Butterfly Valve 1. Routine Inspections Check for leaks, corrosion, or unusual noises during operation. Inspect the valve body, disc, and stem for signs of wear or damage. Ensure the actuator (if equipped) functions correctly. 2. Periodic MaintenanceStep 1: Cleaning Remove debris or buildup from the valve interior and disc periodically. For corrosive media, clean more frequently to prevent seat damage. Step 2: Lubrication Lubricate the stem and actuator moving parts as recommended by the manufacturer.